Not sure this is the right product for your problem? Click HERE to find out which product is best for you.

The Basement Self Solve Epoxy Injection Basement Wall Crack Repair Kit is an effective and affordable way to fix a concrete basement wall crack and restore the structure of the concrete. This is a premium product and is not sold in stores!

Epoxy Injection Basement Wall Crack Repair Kit fast facts:

• The epoxy injection basement wall crack repair kit can be used on cracks measuring 8-10LF.
• The epoxy injection basement wall crack repair kit restores the structure of the concrete.
• The epoxy injection basement wall crack repair kit is a permanent solution: you only need to apply it once!
• The epoxy injection basement wall crack repair kit is effective and affordable.

Epoxy Injection Basement Wall Crack Repair Kit Instructions

The BASEMENT SELF SOLVE CRACKBOND kit includes all of the materials and accessories for low-pressure injection and repair of approximately 8 – 10 linear feet of cracks.

• 2 nozzles (use with The BASEMENT SELF SOLVE CRACKBOND Epoxy LV)
• 12 surface ports and caps
• 2 Jars BASEMENT SELF SOLVE CRACKBOND Removable Surface Seal and Port Adhesive
• 2 The BASEMENT SELF SOLVE CRACKBOND Epoxy LV cartridges
• 2 pair rubber gloves
• 1 plastic trowel 
•  Complete instructions 

Required Tools (not included)

Standard caulking gun/tool

Crack Preparation

Place drop cloth on the floor in front of work area. Remove loose or flaking concrete, efflorescence, paint or any coatings to approximately 1-2 inches on either side of the crack. Wipe the surface clean of dust after brushing. The crack surface must be dry for proper installation of injection ports and surface seal. For the best results if wet, wait a few days until the surface dries or if necessary, use a hot air gun, hair drier, or oil free compressed air to dry.

Surface Port Placement

As a rule of thumb, ports are placed 8” apart centered over the crack, starting at a point closest to the floor (vertical cracks).   Remove caps from surface ports and set aside.

Surface Port Attachment And Sealing Of The Crack

1. Be prepared to work quickly with mixed adhesive.  Pour small equal amounts of surface seal and port adhesive (about ¼ of each jar) onto a scrap piece of cardboard.  Mix well for about a minute with the trowel (repeat this step each time you run out of mixed adhesive). Apply a small amount of mixed adhesive to the bottom of the port base. Place the port starting at the bottom of the crack and repeat every 8” until the entire crack is ported. NOTE! Do not allow the adhesive to block the bottom of the port opening or the crack under it.

2. The next step is to work the mixed surface seal along the entire length of the crack using the plastic trowel. The recommended adhesive application is 1/8” thick and 1” wide. Make sure to mound sufficient extra epoxy around the base of the ports.

3. Let the surface seal and port adhesive cure before beginning injection, about 2 hours or until fingernail hard.

Injection Procedure

1. Place the Epoxy cartridge in your caulking gun. Remove plastic nut, mount mixing nozzle, reattach plastic nut.

2. Place the nozzle into to the lowest port and begin pressing gently.  Use about one tube every four to five feet. .

4. Begin injecting slowly with low pressure allowing the injection epoxy time to flow into and fill all small fissures, until the foam begins to flow from the port above it. Plug the first port with the cap provided, and move up to the next port. Repeat this procedure until the entire crack has been filled with the epoxy. Note! The secret to effective crack injection is patient low-pressure introduction of the foam. Small or hairline cracks may take up to 2 minutes at each port for proper filling to take place.

Clean Up

The surface seal can be removed by striking with chisel after epoxy has cured which takes about 24 hours.