All Products Item ID: #178


Tie Rod and Snap Tie KIT




Product Information:

Not sure this is the right product for your problem? Click HERE to find out which product is best for you. About the Basement Tie Rod / Snap Tie Kit The Basement Self-Solve Tie Rod / Snap Tie Kit is designed to stop water leaking in through tie rods / snap ties. Tie rods and snap […]

Item Description

Not sure this is the right product for your problem? Click HERE to find out which product is best for you.

About the Basement Tie Rod / Snap Tie Kit

The Basement Self-Solve Tie Rod / Snap Tie Kit is designed to stop water leaking in through tie rods / snap ties. Tie rods and snap ties are the metal rods that run through your poured concrete foundation walls or any small void through a poured concrete foundation. It is injected under pressure to get into small confined voids. It expands and stops water at its source.

The Tie Rod / Snap Tie Kit can also be used to fill the void in a honeycomb area. Honeycomb on a foundation is basically when the foundation is poured and not vibrated properly thus allowing edges to have voids or holes after the forms are removed.

Prep Work 

The Basement Self Solve Tie Rod / Snap Tie kit requires a minimum amount of prep work. Clean the area to be injected with a wire brush and clean away any dust or debris. The injection port is then set directly over the tie rod / snap tie and you seal around the port. After it dries then it is ok to start to inject the product.

Product Comparison

Our competitor’s products usually require more involved prep work Their product is not injected under high pressure which means it will not be able to get into the small confined voids. It is only a surface patch that will eventually leak and or create excessive moisture. 

This Tie Rod / Snap Tie Kit includes:

  • 2 nozzles
  • 10 surface ports
  • 2 jars Surface Seal and Port Adhesive
  • 1 Urethane cartridge
  • 2 cartridge for water
  • 2 rubber gloves
  • 1 plastic trowel
  • 2 mixing sticks
  • Detailed instructions

Needed but not included: Standard caulking gun

Additional injection ports can be requested and added to the order at additional cost of $1.00 per injection port.

Item Reviews

One Response to “Tie Rod and Snap Tie KIT”

  1. Nice post. I was checking constantly this blog and I am impressed! Very helpful information specifically the last part :) I care for such info a lot. I was looking for this certain information for a very long time. Thank you and best of luck.

Leave a Reply


Basement Waterproofing Products is Upfront